2006/07/10 by Y. F. Wu, G. Yan, Wu, Y. F. +17
Physics and Astronomy · #FOS: Physical sciences #Superconductivity (cond-mat.supr-con) #cond-mat.supr-con
paper · pdf · doi:10.48550/arxiv.cond-mat/0607223
11 pages, 6 figures
arxiv created 2006/07/10 · arxiv updated 2009/12/01
The powder-in-tube MgB2 wires were prepared by high energy milling of Mg and B powder. The powder was not mechanically alloyed for 2h short milling time. However, the MgB2 grains in wires are very small (20 100nm) and resembled to the dimple after post-heat treatment. The clear evidence for transcrystlline fracture is observed. It indicated that the grain connection was greatly improved and the fluxing pinning was significantly enhanced. Another point to view is no intermediate annealing was adopted during the whole rolling process. The influence of the post-heat treatment on the transport current density was studied. Despite the lower Tc of about 35K, the transport current density reaches to 3X10E4A/cm2 at 15K and 3.5T for 700 sintered wires.