2017/01/12 by Marek Kozicki, Malwina Jaszczak, Piotr Maras +3 · 11 citations
Physics and Astronomy · Medicine · #Advanced Radiotherapy Techniques #Radiation Therapy and Dosimetry #Medical Imaging Techniques and Applications
paper · doi:10.1088/1361-6560/aa5089
Abstract This work presents an improvement of the VIPAR nd (‘nd’ stands for ‘normoxic, double’, or VIP) polymer gel dosimeter. The gel composition was altered by increasing the concentration of the monomeric components, N -vinylpyrrolidone (NVP) and N , N ′-methylenebisacrylamide (MBA), in co-solvent solutions. The optimal composition (VIPAR CT , where ‘CT’ stands for computed tomography, or VIC) comprised: 17% NVP, 8% MBA, 12% t-BuOH, 7.5% gelatine, 0.007% ascorbic acid, 0.0008% CuSO 4 × 5H 2 O and 0.02% hydroquinone. The following characteristics of VIC were achieved: (i) linear dose range of 0.9 _ 30 Gy, (ii) saturation for radiation doses of over 50 Gy, (iii) threshold dose of about 0.5 Gy, (iv) dose sensitivity of 0.171 Gy −1 s −1 , which is roughly 2.2 times higher than that of VIP (for nuclear magnetic resonance measurements). It was also found that VIC is dose- rate-independent, and its dose response does not alter if the radiation source is changed from electrons to photons for external beam radiotherapy. The gel responded similarly to irradiation with small changes in radiation energy but was sensitive to larger energy changes. The VIC gel retained temporal stability from 20 h until at least 10 d after irradiation, whereas spatial stability was retained from 20 h until at least 6 d after irradiation. The scheme adopted for VIC manufacturing yields repeatable gels in terms of radiation dose response. The VIC was also shown to perform better than VIP using x-ray computed tomography as a readout method; the dose sensitivity of VIC (0.397 HU Gy −1 ) was 1.5 times higher than that of VIP. Also, the dose resolution of VIC was better than that of VIP in the whole dose range examined.