Waveforms for sub-THz 6G: Design Guidelines

2023/06/15 by Muris Sarajlić, Sarajlić, Muris, Nuutti Tervo +21 · 1 citation
Engineering · #Antenna Design and Analysis #FOS: Electrical engineering #Microwave Engineering and Waveguides #Radio Frequency Integrated Circuit Design #Signal Processing (eess.SP) #electronic engineering #information engineering

paper · pdf · doi:10.48550/arxiv.2306.09183

openalex publication_date 2023/06/15 · openalex created_date 2025/10/10 · openalex updated_date 2026/07/28

Abstract

The projected sub-THz (100 - 300 GHz) part of the upcoming 6G standard will require a careful design of the waveform and choice of slot structure. Not only that the design of the physical layer for 6G will be driven by ambitious system performance requirements, but also hardware limitations, specific to sub-THz frequencies, pose a fundamental design constraint for the waveform. In this contribution, general guidelines for the waveform design are given, together with a non-exhaustive list of exemplary waveforms that can be used to meet the design requirements.

Cited by

• Radio over Fiber with Cascaded Structure: Algorithm for Uplink Positioning

Related

• On the Potential of Using Sub-THz Frequencies for Beyond 5G
• Millimeter-wave and Terahertz Spectrum for 6G Wireless
• Hardware Aspects of Sub-THz Antennas and Reconfigurable Intelligent Surfaces for 6G Communications
• CmWave and Sub-THz: Key Radio Enablers and Complementary Spectrum for 6G
• Six Critical Challenges for 6G Wireless Systems