2025/05/01 by Piao Qu, Guozhen Liang, Muhammad Irfan Hussain +5 · 1 voice · 4 citations
Chemistry · Engineering · Materials Science · #Additive Manufacturing and 3D Printing Technologies #Advanced ceramic materials synthesis #Photopolymerization techniques and applications
paper · doi:10.1088/2631-7990/add2e1
openalex publication_date 2025/05/01 · openalex created_date 2025/10/10 · openalex updated_date 2026/07/31
Abstract The combination of silicon carbide (SiC) ceramics and stereolithography technology shows promise for manufacturing complex-shaped SiC components, expanding application possibilities. However, high sintering temperature and structural-performance anisotropy limit the practical use of 3D-printed SiC components. Herein, a novel method is introduced to produce high-specific-strength SiC-based ceramics at a relatively low temperature of 1 100 ℃. A mixed SiC/SiO 2 slurry (30% SiO 2 and 70% SiC by volume) with a solid loading of up to 40% was prepared to improve UV light penetration and printability. Additionally, incorporating a high content of methyl-phenyl-polysiloxane (PSO) solution (75% by weight) enabled low-temperature pyrolysis of SiC/SiO 2 /PSO ceramics. The SiC/SiO 2 /PSO ceramic lattices after pyrolysis achieved a specific strength as high as (1.03 × 10 5 ) N·m·kg −1 and a density of 1.75 g·cm −3 , outperforming similar SiC-based lattices structures of similar porosities. The bending strength of (95.49 ± 8.79) MPa was comparable to that of ceramics sintered at 1 400 ℃ or higher. Notably, the addition of the silicon carbide oxide (SiOC) phase reduced anisotropy, lowering the transverse and longitudinal compression strength ratios from 1.87 to 1.08, and improving mechanical properties by 79%. This improvement is attributed to SiOC shrinkage, promoting a uniform distribution of sintered components, resulting in a more robust and balanced material structure. This method offers valuable insight into the additive manufacturing (AM) of SiC-based ceramics at lower temperatures and provides new guidance for controlling anisotropy in 3D-printed ceramic parts.