2021/02/19 by Tsurusawa, Hideyo, Nakanishi, Nobuto, Kawano, Kayoko +3
#FOS: Physical sciences #Instrumentation and Detectors (physics.ins-det) #Materials Science (cond-mat.mtrl-sci)
paper · doi:10.48550/arxiv.2102.09698
Aberration-corrected scanning transmission electron microscopy (STEM) is widely used for atomic-level imaging of materials. To accelerate the discovery of new materials based on atomic-level investigations, the throughput of aberration-corrected STEM experiments becomes more and more important. However, the throughput of the full workflow of aberration-corrected STEM is still quite low. A fundamental problem is that the preparation of high-quality thin STEM samples (lamellae) depends on manual operation. Here, inspired by the recent successes of "robot scientists", we demonstrate robotic fabrication of high-quality lamellae by focused-ion-beam (FIB) with full automation software. First, we show that robotic FIB can prepare lamellae with a high success rate, where the robotic FIB controls rough-milling, lift-out, and final-thinning processes. Then, we optimize the FIB parameters of the final-thinning process for single crystal Si. Aberration-corrected STEM imaging of these Si lamellae shows atomic-level images with 55 pm resolution. We also demonstrate robotic fabrication of high-quality lamellae of SrTiO3 and sapphire. The robotic FIB system will resolve the current bottleneck of the full workflow of aberration-corrected STEM analysis and accelerate materials discovery based on atomic-level imaging.